污泥活性炭处理染料废水的研究

采用污泥活性炭处理酸性品红模拟染料废水,研究了pH值、污泥活性炭投加量、温度、吸附时间等因素对染料废水的脱色率和COD去除率的影响。探讨了污泥活性炭处理染料废水的机理。实验结果表明:污泥活性炭表现出良好的吸附性能,随着酸性品红染料废水浓度的增加,脱色率先增大后减小,COD去除率的变化曲线与脱色率的曲线呈现相似的走势,但在脱色过程中,只有部分染料分子被吸附到污泥活性炭的结构中,另一部分脱色应归因于水溶液中的氢离子吸引染料分子中的碱性助色基团;随着污泥活性炭投加量的增加,脱色率逐渐增大,COD去除率一直减小;由于染料分子中的显色基团和助色基团与废水溶液中氢离子和氢氧根离子之间的相互作用,导致pH对处理效果的影响比较明显,脱色率和COD去除率均在pH为弱酸性范围内效果比较好;随水浴时间的增加,脱色率逐渐增加,COD去除率很低并一直减小;温度的升高使脱色率先增大后减小,COD去除率整体逐渐减小。通过正交试验得到最佳工艺参数为:pH值取5,水浴时间取6.5 h,水浴温度取20℃,染料废水浓度取2.5 mg/L,活性炭投加量取2.5 g,其脱色率为47.73%,COD去除率为62.62%。     

含丙烯腈废水处理技术发展现状与试验研究

含丙烯腈废水危害大、难降解,而用生化法对该类废水进行预处理的难点在于工艺的选择。文章较系统地概述了含丙烯腈废水处理技术的发展现状,并重点研究了“水解酸化＋SBR工艺＋生物滤池技术”处理工艺的反应器启动阶段。研究结果表明：1．水解酸化工艺可用于含丙烯腈废水的处理;2．SBR反应器处理效果良好,COD的平均去除率在70％以上,而且对进水水质的变化适应性较强;3．生物滤池技术应用于废水处理可显著提高COD的去除率。上述研究成果为下一步进行水解酸化＋生物滤池技术＋SBR处理工艺的效果试验奠定了基础。     

活性黄染料废水脱色动力研究

本文采用草酸铁法（UV/Fe（C2O4）33-/H2 O2）氧化活性黄染料废水,其动力学模型为拟一级动力学反应,反应速率常数分别为0.01084 s-1,通过动力学研究方法获得染料废水脱色反应的半衰期为68s;考察了pH值和反应温度的变化对氧化反应动力学的影响,初始pH值在3.0～4.0之间,对于草酸铁法羟自由基氧化脱...     

掺钴水钠锰矿对铅的吸附及对砷的氧化

为了研究过渡金属离子掺杂对锰氧化物作为环境友好材料物理化学性质的影响,在浓盐酸还原高锰酸钾制备水钠锰矿过程中添加氯化钴,在常压回流条件下一步合成了三维纳米微球状水钠锰矿,考察了其铅吸附和砷氧化能力.应用粉晶X射线衍射、化学分析、N2物理吸附、场发射扫描电镜（FE-SEM）、X射线光电子能谱（XPS）等手段表征产物晶体结...     

双极电化学氧化降解水中苯胺

采用钛基氧化物涂层材料（Ti/SnO2-Sb2O5）为阳极,石墨为阴极,在含Fe2＋和不含Fe2＋2种电解质条件下研究了苯胺的电化学氧化降解效率和机制.结果表明,Ti/SnO2-Sb2O5阳极氧化降解有机物的电位约2.0 V±0.1 V,而石墨阴极还原O2生成H2 O2的优化电位为-0.65 V.H2 O2单独作用不能...     

三维电极处理腈纶聚合废水的条件优化研究

采用填充粒状活性炭的三维电极处理腈纶聚合废水,考察实验条件对污染物去除效果的影响以及废水处理前后可生化性的变化.阳极为Ti/SnO₂-Sb₂O₃网状极板,阴极为网状钛电极,分别考察了停留时间、 电解电压、 pH值、 曝气量对废水中污染物去除效果的影响.结果表明,电解电压和pH值对废水有机物的去除率影响较大,在最优实验条件：电解电压为15V,pH值为3,曝气量400 mL/min的条件下电解120 min,腈纶聚合废水的COD、 TOC和丙烯腈的去除率分别为32.59%、 22.17%和89.70%,并且经过电解处理,废水BOD₅/COD值从0.02上升至0.42,可生化性显著提高,为生物处理提供了条件.     

还原-ZPF催化氧化降解2,4-DNT效果及其机制

以实验室制备的α-FeOOH柱撑人造沸石（zeotileartificial pillared byα-FeOOH,ZPF）为催化剂,并利用FTIR与XRD技术进行表征,采用批式实验研究其催化H2O2氧化去除地下水中难降解有机污染物2,4-二硝基甲苯（2,4-DNT）的效能,对比分析不同pH条件下Fe0还原、ZPF催化...     

The performance of nitrate-reducing Fe(II) oxidation processes under variable initial Fe/N ratios: The fate of nitrogen and iron species

•Bacterially-mediated coupled N and Fe processes examined in incubation experiments. •NO₃⁻ reduction was considerably inhibited as initial Fe/N ratio increased. •The maximum production of N₂ occurred at an initial Fe/N molar ratio of 6. •Fe minerals produced at Fe/N ratios of 1–2 were mainly easily reducible oxides. The Fe/N ratio is an important control on nitrate-reducing Fe(II) oxidation processes that occur both in the aquatic environment and in wastewater treatment systems. The response of nitrate reduction, Fe oxidation, and mineral production to different initial Fe/N molar ratios in the presence of Paracoccus denitrificans was investigated in 132 h incubation experiments. A decrease in the nitrate reduction rate at 12 h occurred as the Fe/N ratio increased. Accumulated nitrite concentration at Fe/N ratios of 2–10 peaked at 12–84 h, and then decreased continuously to less than 0.1 mmol/L at the end of incubation. N₂O emission was promoted by high Fe/N ratios. Maximum production of N₂ occurred at a Fe/N ratio of 6, in parallel with the highest mole proportion of N₂ resulting from the reduction of nitrate (81.2%). XRD analysis and sequential extraction demonstrated that the main Fe minerals obtained from Fe(II) oxidation were easily reducible oxides such as ferrihydrite (at Fe/N ratios of 1–2), and easily reducible oxides and reducible oxides (at Fe/N ratios of 3–10). The results suggest that Fe/N ratio potentially plays a critical role in regulating N₂, N₂O emissions and Fe mineral formation in nitrate-reducing Fe(II) oxidation processes.     

Evaluation of the technoeconomic feasibility of electrochemical hydrogen peroxide production for decentralized water treatment

• Gas diffusion electrode (GDE) is a suitable setup for practical water treatment. • Electrochemical H₂O₂ production is an economically competitive technology. • High current efficiency of H₂O₂ production was obtained with GDE at 5–400 mA/cm². • GDE maintained high stability for H₂O₂ production for ~1000 h. • Electro-generation of H₂O₂ enhances ibuprofen removal in an E-peroxone process. This study evaluated the feasibility of electrochemical hydrogen peroxide (H₂O₂) production with gas diffusion electrode (GDE) for decentralized water treatment. Carbon black-polytetrafluoroethylene GDEs were prepared and tested in a continuous flow electrochemical cell for H₂O₂ production from oxygen reduction. Results showed that because of the effective oxygen transfer in GDEs, the electrode maintained high apparent current efficiencies (ACEs,>80%) for H₂O₂ production over a wide current density range of 5–400 mA/cm², and H₂O₂ production rates as high as ~202 mg/h/cm² could be obtained. Long-term stability test showed that the GDE maintained high ACEs (>85%) and low energy consumption (<10 kWh/kg H₂O₂) for H₂O₂ production for 42 d (~1000 h). However, the ACEs then decreased to ~70% in the following 4 days because water flooding of GDE pores considerably impeded oxygen transport at the late stage of the trial. Based on an electrode lifetime of 46 days, the overall cost for H₂O₂ production was estimated to be ~0.88 $/kg H₂O₂, including an electricity cost of 0.61 $/kg and an electrode capital cost of 0.27 $/kg. With a 9 cm² GDE and 40 mA/cm² current density, ~2–4 mg/L of H₂O₂ could be produced on site for the electro-peroxone treatment of a 1.2 m³/d groundwater flow, which considerably enhanced ibuprofen abatement compared with ozonation alone (~43%–59% vs. 7%). These findings suggest that electrochemical H₂O₂ production with GDEs holds great promise for the development of compact treatment technologies for decentralized water treatment at a household and community level.     

高铁酸钾氧化去除弱碱性地下水中低浓度石油类污染物实验研究

研究一般地下水弱碱性水溶液中,高铁酸钾对低浓度石油烃类污染物的氧化去除率。采用0#柴油模拟石油类污染物试验水样,氧化反应在200mL烧杯中模拟完全混合状态完成。实验分析浓度分别为5.02mg/L、2.05mg/L、1.01mg/L和0.52mg/L 4个水样石油类污染物氧化去除率。实验研究显示,石油类污染浓度与高铁酸钾浓度分别按1∶1、1∶2和1∶3投加进行配比,最大氧化去除率97.51%,平均氧化去除率89.46%,氧化反应结束时间为25T。采用乙酸等效计算的导致溶液p H降低小分子有机酸累积量较小;在高铁酸钾过量条件下,石油类污染物氧化反应近似为一级反应。